Cable Kit for 16′ KlassicPro, 6 section boompole (KP16). Requires a bottom module (KPCCR) to work. Top of cable features the New KlassicPro Right Angle Low Profile 3 pin connector. The KlassicPro, 6 section boompoles have a removable headpiece therefore no soldering is required, simply drop the cable through the top section once the headpiece is removed, plug the TA3 into your bottom right angle exit module (KPCCR) and attach to the bottom of your KP16 boompole. Made in the USA, K-Tek’s KlassicPro cable has thicker gauge wire and stronger shielding than previous versions.
K-Tek has created a higher quality coil cable featuring a brand new, low profile right angle connector. The new KlassicPro Cable incorporates thicker gauge wiring and aluminum shielding to make it both stronger and ultra-protected fromradio frequency (RF) interference. The new KlassicPro Right Angle connector is smaller, lighter, serviceable, and made with the popular Neutrik connector as its base. A new solid strain relief makes the Right Angle connector remarkably robust while securely holding the wiring in place. As an added benefit, the connector orientation can be changed by simply unthreading its housing, rotating it to the desired position, and locking it back in place.
The TA3 at the base of the cable is surrounded by a machined Delrin shell which secures the cable to the connector. Simply plug the TA3 into the male end of the KPCCR module. In extreme weather conditions it may be wise to unplug and remove the cable from inside the pole. Keeping the bottom open by removing the bottom module or adding the flow through base (KPFT- soon to be released) will allow water to drain through the pole instead of filling the inside of the tubes. Made in the USA.